Le code pour le capteur humidité/température branché sur le port D3 de l'arduino marche bien mais je souhaite brancher  deux capteurs humidité/température sur mon arduino et je ne sais pas comment adapter le code ci-dessous pour avoir la mesure des deux capteurs en même temps.

Merci d'avance,

// Example testing sketch for various DHT humidity/temperature sensors
// Written by ladyada, public domain

#include "DHT.h"

// Uncomment whatever type you're using!
//#define DHTTYPE DHT11   // DHT 11
#define DHTTYPE DHT11  // DHT 22  (AM2302)
//#define DHTTYPE DHT21   // DHT 21 (AM2301)
//#define DHTTYPE DHT10   // DHT 10
//#define DHTTYPE DHT20   // DHT 20

/*Notice: The DHT10 and DHT20 is different from other DHT* sensor ,it uses i2c interface rather than one wire*/
/*So it doesn't require a pin.*/
#define DHTPIN 3           // what pin we're connected to（DHT10 and DHT20 don't need define it）
DHT dht(DHTPIN, DHTTYPE);  //   DHT11 DHT21 DHT22
//DHT dht(DHTTYPE);         //   DHT10 DHT20 don't need to define Pin

// Connect pin 1 (on the left) of the sensor to +5V
// Connect pin 2 of the sensor to whatever your DHTPIN is
// Connect pin 4 (on the right) of the sensor to GROUND
// Connect a 10K resistor from pin 2 (data) to pin 1 (power) of the sensor


#if defined(ARDUINO_ARCH_AVR)
#define debug Serial

#elif defined(ARDUINO_ARCH_SAMD) || defined(ARDUINO_ARCH_SAM)
#define debug SerialUSB
#else
#define debug Serial
#endif

void setup() {

  debug.begin(115200);
  debug.println("DHTxx test!");
  Wire.begin();

  /*if using WIO link,must pull up the power pin.*/
  // pinMode(PIN_GROVE_POWER, OUTPUT);
  // digitalWrite(PIN_GROVE_POWER, 1);

  dht.begin();
}
void loop() {
  float temp_hum_val[2] = { 0 };
  // Reading temperature or humidity takes about 250 milliseconds!
  // Sensor readings may also be up to 2 seconds 'old' (its a very slow sensor)
  if (!dht.readTempAndHumidity(temp_hum_val)) {
    debug.print("Humidity: ");
    debug.print(temp_hum_val[0]);
    debug.print(" %\t");
    debug.print("Temperature: ");
    debug.print(temp_hum_val[1]);
    debug.println(" *C");
  } else {
    debug.println("Failed to get temprature and humidity value.");
  }
  delay(1500);
}